MikMek SubMicro Návod k obsluze

Procházejte online nebo si stáhněte Návod k obsluze pro Tisk a skenování MikMek SubMicro. MikMek SubMicro Operator`s manual Uživatelská příručka

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 22
  • Tabulka s obsahem
  • ŘEŠENÍ PROBLÉMŮ
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 0
0
M
ICRO MODEL TICKET PRINTERS
Operator’s Manual
Rev A: 10/16/2002
0,&52
0,&523/86
6XE0,&52
'
8$/0,&52
Zobrazit stránku 0
1 2 3 4 5 6 ... 21 22

Shrnutí obsahu

Strany 1 - Operator’s Manual

0MICRO MODEL TICKET PRINTERS Operator’s ManualRev A: 10/16/2002 0,&520,&523/866XE0,&52'8$/0,&52

Strany 2

98.1.1 Load Switch and Tear OptoThere is one micro switch located below the paper guide. This switch is used to sense the presence of ticket stock in

Strany 3 - FCC NOTICE

10There is one optical device mounted on an aluminum bracket. The opto controls the tear position. Removal or adjustment of the opto should be done

Strany 4 - 2.0 Unpacking the Printer

118.1.2 THERMAL PRINT HEADThe print head should be cleaned periodically to prevent debris from building up on the print element. The required cleanin

Strany 5

12FOR PRINTERS WITH RED HANDLED LEVER 1. Make sure power is off and the AC cord is disconnected from the printer. 2. DO NOT UNPLUG CABLE FROM PRINT HE

Strany 6 - 5.0 Configuration

138.1.4 Ticket Width Adjustment To adjust the paper path for use with a different ticket width, loosen the two thumbscrews located on the adjustable s

Strany 7

148.2 Logic Board The printed circuit boards used in this product have been manufactured using surface mount technology. These printed circuit boards

Strany 8

158.2.2 Logic Board (Installation) 1. Align Main Logic Board so that the four mounting holes are above the four fasteners. 2. Press logic boar

Strany 9

16P51-1002DRIVE PULLEY, 32TP51-1003 DRIVE PULLEY, 34T 421366-2NMICENTRANCE PAPER GUIDE, MICRO MB 2” P29-1002 FUSE, 2A SB P29-1001FUSE, 1A SB4231

Strany 10

17P49-1000SHOULDER SCREW, PAPER GUIDEP44-1011 SPRING, PRESSURE ADJ. BLOCK P41-1014STAND OFF, CUTTER STRAP MTG.422590 STEPPER MOTOR ASSY. (FGL20,40,2

Strany 11

1810.0 Troubleshooting Guide This is a simplified troubleshooting guide listing some of the typical problems. It is not intended to provide technica

Strany 12 - 8.1.2 THERMAL PRINT HEAD

1Table of Contents Page FCC Notice & Warranty Information 2 1.0 Introduction 3 2.0 Unpacking the

Strany 13

19 a. Clean print head. Consult “Thermal Print Head” section. b. Replace thermal head. 8. NO PRINT OUT a. Check head cable for electrical con

Strany 14

20APPENDIX A - CONTROL PANEL The FGL44 printers allow the user to adjust various printer options through the control panel. To access the control pan

Strany 15 - 8.2.1 Logic Board (Removal)

21The following is a brief overview of some representative Menu options: BAUD RATE? Controls the serial interface baud rate, parity bit, data bits an

Strany 16 - 9.0 Spare Parts List

2FCC NOTICE NOTE: The equipment has been tested and found to comply with the limits for a class A digital device, pursuant to part 15 of the FCC rule

Strany 17

31.0 IntroductionThe BOCA MICRO series printers are direct thermal ticket printers designed for point of sale ticketing environments. This manual wil

Strany 18

43.0 Important Safety Information :$51,1*7KHDSSHDUDQFHRIWKLVV\PEROLQGLFDWHVWKHSUR[LPLW\RIDQH[SRVHGKLJKYROWDJHDUHD3OHDVHIROORZDOO

Strany 19 - 10.0 Troubleshooting Guide

54.0 Installation The BOCA MICRO series printer was designed to be mounted either on a desktop or shelf (horizontal model) or vertically in a counter

Strany 20

66.0 Standard Interface Pinouts SERIAL PINOUTS RS232 (standard) RS232 (PC type)PIN FUNCTION PIN FUNCTION 2 Printer Transmit

Strany 21 - APPENDIX A - CONTROL PANEL

77.0 Thermal Paper - Theory & SpecificationThe print head’s life expectancy is composed of both a mechanical and an electrical component. Both of

Strany 22

88.0 Maintenance and AdjustmentsYour ticket printer is solidly constructed and has been designed for high volume use. It requires minimal care to p

Komentáře k této Příručce

Žádné komentáře